■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
▼
Installing the Hardware
DS1104 Hardware Installation and Configuration March 2004
27
▲
■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
2 Select an unused 32-bit PCI slot.
T
PCI slots are shorter than ISA or EISA slots and typically white.
3 Unscrew and remove the bracket that covers the card-slot opening
on the rear side of the enclosure.
4 Insert the board in the slot. Press it down firmly so that the
contacts are securely seated in the slot.
5 When the board is firmly seated in the slot, secure the bracket with
the screw you removed in step 4.
6 Close the enclosure and reconnect the PC to the power supply.
7 Turn on the host PC.
The host PC should boot as usual. Now you can run ControlDesk to
verify the installation, see Verifying the System on page 31.
If the PC does not boot, switch off the power supply immediately and
check that the board is inserted firmly.
For information on connecting external devices to the I/O connector of
the DS1104, see How to Connect External Devices to a Board on
page 72.
To Next Page
Loading...
Need help?
General
