dSPACE DS1104 - How to Connect External Devices to a Board

Connecting External Devices to the dSPACE System ▲ ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■
DS1104 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■ ▼
72
■■■■■■■■■■■■■■■▼
How to Connect External
Devices to a Board
To connect external devices to the DS1104
C
CAUTION! Connecting external devices while the power supply
is switched on may damage the dSPACE hardware.
■ Do not connect or disconnect any device while the power supply is
switched on.
■ Turn off the host PC and the external devices beforehand.
1 Turn off all external devices which are to be connected to the
dSPACE system
2 Turn off the host PC.
3 Disconnect the host PC and all devices connected to it from the
power supply.
C
WARNING! Hazardous voltages.
Risk of electric shock and/or damage to the hardware.
■ Do not connect any high-voltage devices to the I/O connectors of
the hardware.
■ Do not apply voltages/currents outside the specified ranges to the
connector pins.
4 Connect the devices belonging to your application to the DS1104
via the adapter cable.
N
Do not mix up the connectors of the adapter cable. They are
labeled P1A, P1B.
5 Reconnect the host PC and all external devices to the power
supply.