Connecting External Devices to the dSPACE System
▲
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
DS1104 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■
▼
74
■■■■■■■■■■■■■■■▼
How to Connect External
Devices to a Connector Panel
To connect external devices to a connector panel
C
CAUTION! Connecting external devices while the power supply
is switched on may damage the dSPACE hardware.
■ Do not connect or disconnect any device while the power supply is
switched on.
■ Turn off the host PC and the external devices beforehand.
1 Turn off all external devices which are to be connected to the
dSPACE system.
2 Turn off the host PC.
3 Disconnect the host PC and all devices connected to it from the
power supply.
C
WARNING! Hazardous voltages.
Risk of electric shock and/or damage to the hardware.
■ Do not connect any high-voltage devices to the I/O connectors of
the hardware.
■ Do not apply voltages/currents outside the specified ranges to the
connector pins. The isolation of the panels has been designed for
low-voltage operation only.
4 Connect the devices belonging to your application to the panel.
5 Reconnect the host PC and all external devices to the power
supply.
6 Turn on the host PC.
The host PC should boot as usual.
7 Turn on all external devices connected to the dSPACE system.
To Next Page
Loading...
Need help?
General
