Need help?Do you have a question about the DTS JACK and is the answer not in the manual?
General| Source | LED |
|---|---|
| Colors | RGBW |
| Frequency | 50/60 Hz |
| Dimmer | 0-100% |
| Control | DMX512 |
| Voltage | 100-240V |
Read the instruction contained in this user manual carefully, as they give important information regarding safety during installation, use and maintenance.
The unit is guaranteed for 36 months from the date of purchase against manufacturing material defects.
MSD Platinum 5R (7.950 Lumens) Colour temperature: 8.000°K Type of connection: PINS 2,8x 0,8mm
50,000 Lux at 5 m (2,5°), 11 coated lenses, dichroic glass reflector, 16-bit motorized zoom, motorized iris, linear dimmer/shutter/strobe.
18-colour wheel with linear selection for perfect 2-colour beams.
Overlapping wheels for multiple effects: customizable gobo wheels, 4-facet rotating prism.
LCD display, soft-keys, DMX 512 control, RDM, ARTNET, Wireless ready, OS updatable via RED BOX interface.
25 DMX channels (default) or 17 DMX channels.
Jack FPR (Unlimited Pan), Jack (540° Pan), 270° Tilt, Tri-phase stepper motors, 16-bit resolution, selectable speed ranges.
Electronic ballast 90-260V 50/60 Hz, 230W power consumption with PFC.
Power saving mode where the lamp dims to 80% after shutter closure.
DMX XLR (3-pole In/Out, 5-pole In/Out), Power supply POWERCONN.
Range of -10°C to 40°C.
11,9 Kg.
Overvoltage circuit protection and overtemperature circuit protection.
Safety: EN 60598-1, EN 60598-2-17. EMC: EN 55015.
Packaging Dimensions (532x430x414mm, 14.4Kg), Unit Dimensions (350x370x560mm, 11.9Kg).
MSD Platinum 5R lamp, POWERCON connector, XLR connectors, 'C' Clamp G QUICK, Rotating Gobo Dicro, User's manual.
Wireless DMX Card, 'C' Clamps (G60, GQUICK, G100), Omega clamp, Safety wire.
Use specific lamp, avoid flammable surfaces, maintain distances, use circuit breaker.
High voltage inside, unplug before servicing, ensure earth connection, use authorized service.
Do not use damaged lenses/filters, avoid direct lamp viewing.
Use secure mounting, safety cable, handle hot surfaces carefully, ensure airflow, limit ambient temp.
IP 20 classification. Use raincovers for outdoor use.
Use a safety cable or chain connected to the unit and suspension truss to prevent accidental falling.
Prevent contact with oil, water, or other liquids to avoid compromising unit function.
Note Pan/Tilt ranges and avoid obstructions in the projector's movement path.
Install in ventilated place, maintain distances from flammable materials and illuminated objects.
Do not block air inlets or cooling fans to prevent overheating.
Ensure constant airflow and do not exceed 40°C ambient temperature.
Use a thermal magnetic circuit breaker and ensure a good earth connection for correct operation.
Select between 25 (default) or 17 DMX channels, with addressing examples provided.
Use UP-DOWN keys to select address, press ENTER to confirm. Hold keys for faster selection.
Set Pan movement to Normal or Reversed. Default is Normal.
Set Tilt movement to Normal or Reversed. Default is Normal.
Adjust Pan speed using a scale from 1 to 8.
Adjust Tilt speed using a scale from 1 to 8.
Control display orientation, standby mode, and contrast level (1-32).
Choose between 17 or 25 DMX control channels.
Lamp ON/OFF selection via DMX, Always ON/OFF, and lamp life time reset.
Adjust lamp parameters for PAN-TILT, ZOOM, and FOCUS without a mixer.
Reset via DMX (enabled/disabled) and unit motor reset.
Adjust Base Fan speed from 1 to 12. Default is 4.
Adjust Lamp Fan speed from 1 to 12. Default is 5.
Control gobo rotation during gobo scrolling for the rotating gobo wheel.
Enable or disable automatic focusing function.
View lamp life, strikes, unit life, software versions, and unit model.
Includes Pan lock, Tilt lock, Pan/Tilt free options, and System Reboot.
Option to restore the unit to its main factory settings.
Electronic calibration for motors: Pan, Tilt, Shutter Zero, Shutter Path, Colour Wheel, Gobo Wheel.
Calibration for Gobo Index, Fixed Gobo, Iris Zero, Iris Path, Prism Zero, Prism Path, Focus, Zoom.
Clean lenses and reflector with a soft, dampened cotton cloth and specialist solution.
Clean fans and air passages approximately every 6 weeks using brush, vacuum, or air compressor.
Replace lamp if damaged or deformed by heat. Lifespan is approximately 2000 hours.
Check for wear, lubricate components, and adjust belt tension as necessary.
Verify correct earthing and connector connections, refasten if needed.
Locate, test, and replace fuse with an equivalent type if necessary.
Lists DMX channels 1-25 and their parameters for the default mode.
Details DMX values and functions for PAN FAR (active on Jack FPR).
Details DMX values and functions for DIMMER (Black-out, Proportional dimmer).
Details DMX values and functions for SHUTTER (Black-out, Open, Strobe, Flash).
Details DMX values for colour modes (Full, Half, Proportional, Rainbow) and colour selections.
Details DMX values for selecting colour modes: Full, Half, Proportional, Rainbow.
Details DMX values for GOBO selection (Open, Gobo 1-9) and speed settings.
Details DMX values for GOBO Mode: Rotation Mode or Index Mode.
Details DMX values for Gobo Rotation/Index and Prism Rotation control.
Details DMX values for fine Gobo Index adjustment.
Details DMX values for Gobo Shake effect (R-L and L-R speeds).
Details DMX values for FIXED GOBO selection (Open, Gobo 1-10) and speed settings.
Details DMX values for FIXED GOBO SHAKE effect (R-L and L-R speeds).
Details DMX values for IRIS control (Open, Linear iris, Closed).
Details DMX values for MACROS (IRIS, BEAM, WASH, SPOT) with various effects.
Details DMX values for selecting MACROS MODE: IRIS, BEAM, WASH, SPOT.
Details DMX values for PRISM: No Effect or Prism Inserted.
Details DMX values for FOCUS control (Linear focus 0-95%).
Details DMX values for FINE FOCUS control (Linear focus 95-100%).
Details DMX values for ZOOM control (Linear zoom).
Details DMX values for Lamp OFF/ON, internal motor reset, and total reset.
Lists DMX channels 1-17 and their parameters for the 17-channel mode.
Details DMX values and functions for PAN msb.
Details DMX values and functions for PAN Isb.
Details DMX values and functions for TILT msb.
Details DMX values and functions for TILT Isb.
Details DMX values and functions for SPEED MOVEMENT.
Details DMX values and functions for PAN FAR (active on Jack FPR).
Details DMX values and functions for DIMMER (Black-out, Proportional dimmer).
Details DMX values and functions for SHUTTER (Black-out, Open, Strobe, Flash).
Details DMX values for colour selection and rotation speeds.
Details DMX values for GOBO selection (Open, Gobo 1-9) and speed settings.
Details DMX values for Gobo Rotation/Index and Prism Rotation control.
Details DMX values for FIXED GOBO selection (Open, Gobo 1-10) and speed settings.
Details DMX values for IRIS control (Open, Linear iris, Closed).
Details DMX values for PRISM: No Effect or Prism Inserted.
Details DMX values for FOCUS control (Linear focus).
Details DMX values for ZOOM control (Linear zoom).
Details DMX values for Lamp OFF/ON, internal motor reset, and total reset.
To Next Page
