steadily for another 5 seconds, which it returns
to display the time of the current lap, updating the
number of laps. When the 30th lap is reached, the
message Full memory is displayed and it is not
possible to record new times: in this case, delete the
saved laps in order to record new ones.
Use the Lap function in the menu (see page
237) to:
- Activate or deactivate the function
- View the recorded lap data
- Delete recorded data
To close the window, press and hold the joystick in
position
for a long time. The window can be closed
keeping the function active.
The instrument panel stops recording the lap by
the stopwatch in the following cases:
- If bike speed is equal to 0 5 seconds from
first lap
- If bike speed drops below 5 km/h (3 mph) for
more than 5 seconds during lap recording.
- If the engine is turned
The following data is recorded for each lap:
- Time
- Maximum reached speed
- Maximum reached RPM
Note
The stopwatch can be only when the
motorcycle speed is higher than 5 km/h (3 mph).
Note
If during lap recording the flash (6) is
pressed to the stopwatch, any
presses occurred within 5 seconds will not be
considered by the instrument panel.
170
To Next Page