The relative window (C, Fig 139) is displayed.
The current ABS On status is displayed at the
of the window and ABS (D, Fig 140) is
displayed in the middle of the window. When ENTER
is pressed Wait... is displayed for a few seconds, then
the ABS system is deactivated with displayed at
the and ABS On (E,Fig 140) shown in the
middle of the window.( Fig 140)
The window remains active as long as the ABS
system is disabled. In this case the window cannot be
closed. Press ENTER to re-enable the ABS system:
once reactivated, the window returns to the previous
condition and it will be possible to close it by pressing
and holding the joystick in position
for a long time.
Note
If an error occurs during the status change from
On to and vice versa, the red Error message is
displayed for a few seconds, then the window shows
the previous status.
4
1
2
3
5
6
7
8
10
12
Air
24
°C
0
km/h
90
°C
10:34
pm
N
Gear
rpm X1000
km
km
km
2017
250
52.3
ENDURO
On
ABS Off
Total
Range
Trip 1
C
DTC
DQS
ABS
DWC
3
3
5
On
Fig 139
Fig 140
172