Entering the new PIN CODE:
The display shows “N:” (NEW) followed by four
flashing dashes "- - - -” (A).
To exit the function without entering a new PIN
CODE, press (2) for 2 seconds.
While if you press (4) with the 4 flashing
dashes “- - - -”, the page for the entering of the new
PIN CODE will be displayed.
1) Only the first digit on the will flashing
with indicated the number “0” (B)
2) Each time you press the (1) the displayed
number increases by one (+ 1) up to "9" and then
back from “0”
3) Each time you press the (2) the displayed
number decreases by one (- 1) up to "0" and then
back from "9"
4) Press (4) to confirm the number and
move on to the following digit which will
flashing.
Repeat the procedures until you confirm all the 4
digits of the new PIN CODE.
Fig 99
119
To Next Page
Loading...
