Repeat the procedures until you confirm all the 4
digits of the PIN CODE.
Note
During this phase it is not possible to quit the
function by pressing (2) for 2 seconds until
the last digit is entered. Therefore, the “EXIT”
indication and the black arrow facing downwards are
not visible until the last digit is entered.
When you press (4) to confirm the and
last digit, the instrument panel verifies the entered
PIN:
●
If the PIN is not correct, the instrument panel
displays “ERROR” flashing for 2 seconds and
then highlights the four dashes "- - - -" for the
old PIN to allow you to try entering the code
(A, Fig 98)again.
●
If the PIN code is correct, the instrument panel
shows “OK” flashing for 2 seconds, and then
displays the page for entering the new PIN
CODE.
118
To Next Page
Loading...
