Low/high beam (version with DRL)
At Key-On, the high beam and low beam lights are
OFF: only the parking lights and the DRL light are
turned on.
the engine the low beam is
automatically switched on if the AUTO mode is set
and the instrument panel detects poor ambient light
(NIGHT): if, on the other hand, the instrument panel
detects good light conditions (DAY), the DRL light
remains on and the low beam remains
If within 60 seconds from the “manual” switching on
of the low / high beam the engine is not the
lights are disabled again
It is possible to switch from DRL to low beam and
vice versa with (5).
It the low beam is activated, it is possible to switch on
the high beam with (7, Fig 18) position (A), or
flash with (3, Fig 18).
If engine is not upon key-on, it is anyway
possible to switch low/high beams on by pushing
(7, Fig 18) positions (B) and (A), or flash with
(3, Fig 18) on LH switch.
To preserve the motorcycle if when
the engine the high/low beams or the DRL lights are
ON, the headlight is automatically switched and
then on again when the engine is
Fig 19
42
To Next Page
Loading...
