Duplo DBM-150T - Page 28

1-18
Chapter 1 Before Operation
Setting item Setting details
Base Psn Adjusts the base position.
(p.2-21)
Adjustable range: -5 to +5
-: The base gets closer to the operator's side.
+: The base gets away from the operator's side.
Variation per unit: Approx. 1 mm/0.04 inch
*The base position cannot be adjusted when a upstream unit is not connected to the DBM-
150.
Trim Psn Determines the base position.
(p.2-17)
Adjustable range: -41 to +6
+: The trimming width is narrower.
-: The trimming width is wider.
Variation per unit: Approx. 0.5 mm/0.02 inch (when the default [0] is selected, the trimming
width is 3 mm/0.12 inch.)
*Displayed only when the binding mode is set to [Saddle/Fold] or [Fold] and the DBM-150T
is connected to the DBM-150 as a downstream unit.
Fine adjustment menu map
+0
+0
+0
+0
+0
+0
Fold Psn
Staple Psn
S/F Psn
Fold Psn
Staple Psn
S/F Psn
Fold Psn
Staple Psn
S/F Psn
+0
+0
Trim Psn
+0
Base Psn
+0
+2
+0
Fold Psn
+0
+0
Back Guide
Adjustment
Side Guide
Back Guide
Adjustment
Adjustment
Adjustment
Adjustment
Adjustment
Adjustment
Adjustment
Side Guide
This is displayed only
when the binding
mode is set to
[Saddle/Fold].
This is displayed only when
the binding mode is set to
[Fold].
This is displayed only when the binding mode is set to [Saddle/Fold]
or [Fold] and the DBM-150T is connected to the DBM-150 as a downstream
unit.