4-1
Chapter 4 Cleaning the Unit
Chapter 4 Cleaning the Unit
1. Cleaning Each Part
• Make sure that you disconnect the power cord from the wall outlet before cleaning.
• Before you use the machine after cleaning, make sure that its surface is completely dry.
1-1. Cleaning the conveyance belt and rollers
Clean the belts and rollers while turning them using a cloth moistened with alcohol.
“2-2. DBM-150 internal parts” (p.1-6)
“2-3. DBM-150T” (p.1-8)
1-2. Cleaning the LCD
Wipe the LCD on the control panel with the dry cloth.
“3. Names of Control Panel” (p.1-11)
Do not use flammable sprays and solvents during cleaning, etc. of internal
parts of the machine and in the vicinity of the machine.
Doing so could cause build-up of gas inside the machine, which in turn could cause ignition, resulting in re
and explosion.
When using alcohol, exercise precaution against re and ventilate well, and after use, store in a safe
place.
Use of other solvents may damage the rubber rollers and resin inside the machine, resulting in malfunction.
To Next Page
Loading...