2-13
Chapter 2 Basic Operation
+0
Back Guide
Step Mode
Side Guide
+0
6
Press the key or key to change the
value.
7
Press the key.
The paper will be ejected to the belt stacker.
Do not move the side guides and the back
guide by hand during the step mode. Once
they are moved, remove paper and start
the step mode again.
6. Checking a Finished Set
Check the binding condition of the booklet ejected in the step mode. Fine adjustment is required when
sheets are not aligned, or the stapling or folding position is unsatisfactory.
6-1. When sheets are not aligned
Adjust the distance between the right and left side guides and the back guide position.
It is necessary to adjust the
side guides.
It is necessary to adjust the
back guide.
It is necessary to adjust both the
back guide and the side guides.
The sheets of paper are not
aligned along the length.
The sheets of paper are
not aligned along the side.
The sheets of paper are not
aligned along the length and side.
6-1-1. Adjusting the position of the back guide
1
When the top screen is displayed, press
the key on the control panel.
+0
+0
Back Guide
Step Mode
Side Guide
2
Press the key to select [Back Guide].
3
Press the key or key to change the
value.
To Next Page
Loading...
Need help?
General
