31
8-2. ADJUSTING THE FOLDING SLIPPAGE IN THE HORIZONTAL DIRECTION
• If folding slips as shown in the figure because the
paper is not cut straight, rotate the “slant
correction” knob to adjust the folding slippage.
1 Rotate the “slant correction” knob to
adjust the folding slippage.
• If folding slippage is as shown in Fig. A, rotate the
knob in the direction of the arrow.
• If folding slippage is as shown in Fig. B, rotate the
knob in the direction of the arrow.
2 After adjustment, be sure to rotate the
“slant correction” knob to adjust the
round holes of the paper feed table to
the pin.
• The position at which the round hole meets the pin
is the standard position.
8. FOLDING ADJUSTMENTS
Slant correction knob
Slant correction knob
Slant correction knob
Round hole
Pin
Slant correction knob
To Next Page
Loading...
