47
(2) When the start button is
pressed, the paper feed ring
rotates but no paper is fed.
13. TROUBLESHOOTING GUIDE
Problem
Check
Correct
(1) The unit does not start when
the start button is pressed.
• Insert the power cord properly
into the outlet.
1 Is the power cord
disconnected ?
3 Is there paper on the paper
feed plate?
• Load some sheets of paper.
2 Is the power switch on ?
• Turn on the switch.
• Set the paper properly.
4 Is the paper on the paper feed
table set properly on the
paper switch?
5 Is the paper stuck? • Remove the paper.
6 Is the top cover open?
• Close the top cover.
• Contact your serviceman.
7 Has a problem occurred
inside the unit?
* The motor will continue to rotate for about five seconds after the paper stacked
on the paper feed table has run out before.
1 Is the paper feed plate
lowered?
• Lower the paper set lever and
raise the paper feed plate.
(3)The main motor does not
rotate.
1 Is the top cover open?
• Close the top cover.
2 Has a problem occurred
inside the unit?
• Contact your serviceman.
(4) The paper is not folded at the
proper folding position.
1 Is the folding plate set
properly?
• Position the folding plate
properly.
2 Environmental conditions
such as static electricity, etc.
may be the cause.
• Change the paper type.
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
‰
To Next Page
Loading...
