42
11. TROUBLESHOOTING
11-1. PAPER HAS JAMMED NEAR THE PAPER FEED RING
1 If paper has jammed near the paper
feed ring, raise the paper set lever
and lower the paper feed table
downwards.
2 Pull the jammed paper towards you.
11-2. PAPER HAS SLIPPED NEAR THE PAPER FEED SECTION
• If the paper stops at the paper feed
section when thick paper is used
(127.9 g/m
2
) and no paper is fed, set
the paper feed pressure to “thick
paper”.
Note : Move the lever as shown in the right figure until
the lever stops.
Paper feed table
Paper
Paper set lever
Paper feed pressure adjusting knob
To Next Page
Loading...
