23
Enter the number of sets to be processed and the number of sheets in one set.
NOTE : The cover page fed from the paper feeder B is not included in the number of sheets of the set.
q Turn the jog dial at the initial screen to display “Number Of Job”, and press the jog dial to confirm the setting.
w Turn the jog dial and display “Number Of Sets” to enter the number of sets or display “Number Of Sheets” to enter the
number of sheets in one set, and press the jog dial to confirm the setting.
5
<When entering the number of sets>
<When entering the number of sheets in one set>
Input Sets No.
7777
Input Sheets No.
1O
e Turn the jog dial and display the desired value, and press the jog dial to confirm the setting. The number of sets can be set
between 1 and 9999. When the DBM-120 Sheet by Sheet is connected, the number of sheets in one set can be set between
1 and 99 in the “Through” mode and 1 and 20 sheets in other modes (1 to 19 when using paper feed tray B). When the
DBM-400 Sheet by Sheet is connected, the number of sheets in one set including the cover when paper feed tray B is used
can be set between 1 and 25 in the “Fold” mode and “Booklet” mode, and between 1 and 30 in the “Side ST” mode and
“Corn.ST” mode.
If the number of sheets in one set or the setting of the downstream processing unit differs from the previous process, enter
“1” for the number of sets, check the set processed by the downstream processing unit, and then process the remaining
sets required.
NOTE : When using the random binding function of the end mark, there is not need to set the number of sheets
for one set.
The number (thickness) of sheets in one set is restricted by the downstream processing unit. Refer to
the instruction manual on the downstream processing unit.
6. OPERATIONS
To Next Page
Loading...
Need help?
General