43
13. OTHER SETTINGS
13-6. Selecting the Separator Air Strength
The separator air strength can be selected from three steps. If paper feed errors occur frequently
at standard value “1”, change the setting and set the most appropriate value. If the paper is large
and thick, set the air strength to high. If the paper is small and thin, set the air strength to low.
Blower Stre. A
1
Turn the jog dial at the initial screen to display “Other Setting”, and press the jog dial to confirm
the setting.
1
Turn the jog dial to display “Blower Strength”, and press the jog dial to confirm the setting.
2
To change the separator air strength of the paper feeder A, turn the jog dial to display “Blower
Stre. A”, and press the jog dial to confirm the setting. To change that of the paper feeder B,
display “Blower Stre. B”, and press the jog dial to confirm the setting.
3
Turn the jog dial and display the desired value at the left edge, and press the jog dial to
confirm the setting.
“1” is the maximum air amount and “3” is the smallest. The standard value is “1”.
4
Select Stre. A
1 2 3
To Next Page
Loading...
Need help?
General