Operation
66 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
To position the sewing material when sewing Plain goods:
1. Position the jacket front part on the fabric sliding plate.
• Left jacket front parts: Position the jacket front part with breast
dart (1) at the light spot (6)
• Right jacket front parts: Position the jacket front part with breast
dart (1) at the light spot (9)
2. Align the pocket opening (12) at the vertical lines of the light spots
(middle knife incision).
The pocket opening (12) is situated between breast dart (1) and side
seam (11).
3. If additionally equipped with vacuum: Press the pedal forwards and
release it.
The vacuum is switched on.
4. Press the pedal forwards.
The transport carriage moves to the loading position. The transport
clamps lower onto the jacket front part.
To position the sewing material when sewing Patterned goods:
1. Mark the flap edge (2) on the jacket according to the pattern.
• Left jacket front parts: Position the jacket front part with the marking
at light spot (4)
• Right jacket front parts: Position the jacket front part with the mark-
ing at light spot (8).
2. Align the pocket opening (12) at the vertical lines of the light spots
(middle knife incision).
The pocket opening (12) is situated between breast dart (1) and side
seam (11).
3. If additionally equipped with vacuum: Press the pedal forwards and
release it.
The vacuum is switched on.
4. Press the pedal forwards.
The transport carriage moves to the loading position. The transport
clamps lower onto the jacket front part.
To make positioning corrections:
1. Press the pedal back.
The transport clamps lift.
2. Press the pedal back again.
The transport carriage returns to its waiting position.
To Next Page
Loading...
