Knife overlap
Prerequisite is that the block 11 is seated flush on the rod 12.
This results in an optimum clamping effect.
–
Loosen screw 6.
(Insert the wrench through the hole in the housing wall)
–
Turn shaft 5.
When the knife 9 is at the lower dead center the overlap
should be 0.5 mm.
–
Tighten screw 6 again.
The block 7 should not touch the link 8.
Note
When the knife has been reground often it may no longer be possible to
set the overlap o f 0.5 mm. In this case the spacer plate 4 can be moved
from below the knife carrier 3 to above the knife carrier.
Setting and pressure of the knife blades
–
Loosen screws 1 and 2.
–
Set the position of the knife.
The knife 9 should lie a little inclined to the counter knife 10.
The knife should cut securely with the least possible pressure.
–
Tighten screws 1 and 2 again.
Note
The higher the knife pressure, the higher the knife wear !
90
56 7 8
1
2
3
4
9
10
9
1
11 12
To Next Page
Loading...
Need help?
General
