DYNACO Slimline Series - Page 38

6● DYNALOGIX II (DY 4000) DYNACO USA
36 THE SAFEST CHOICE Slimline Series RevB.doc1
3. Set the close limit position.
• Press and release the Enter button. ClsLimit displays in the LCD.
• Press and release the Enter button. JogToCls displays in the LCD.
• Press the JOG DOWN button to bring the door down to desired close position. See Figure 6-
12.
JOG DOWN
Button
M-00091
06/13/05
JOG
UP/RESET
JOG
DOWN
CLOSE
OPEN
MC/PB
MENU
ENTER
CLOSE
TIMERS
AC/LOOP
PROGRAM
RUN
TIMERS
MESSAGE DISPLAY COUNTER
MESSAGE DISPLAY COUNTER
JogToCls
Enter
Figure 6-12: JOG DOWN Button
Note: The door is out of phase if it moves up instead of down. Turn power off and switch T2 & T3 on
the terminal block. Turn power on and return to Step One.
• Press and release the ENTER button to save limit setting.
ClsLimit_Set—OK displays in the LCD.
4. Set the photo eye shut-off position.
• Press and release one of the PROGRAM buttons to scroll up or down until the PhtLimit
message displays in the LCD (photo eye shut off position).