59
Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | info@dynaset.com | www.dynaset.com
HYDRAULIC SCREW COMPRESSORS
MAINTENANCE
4. Start the compressor and close air supply line. Allow it run for 3 minutes. Check
the compressor and system for leaks when the system is running.
3min
6.9. REPLACING AIR FILTER ELEMENT
ATTENTION!
Dirt and dust particles must be prevented to get into the air inlet of the
compressor.
1. Remove the filter cover and remove the old filter element.
ATTENTION!
Cleaning the filter element is prohibited. The filter element must always be
replaced in case of soiling!
To Next Page
Loading...
