On the Dynavin homepage, follow the instructions for downloading the firmware.
Download the available update firmware for your Dynavin onto an SD Card. (The card must be
formatted with the FAT 16/31 file system.)
You must extract the files and place them individually in the root directory (not in a folder).
Insert the card into the MMC SD card slot. (Depending on your Dynavin, you may need a micro SD
card or a standard SD card.)
Click the Upgrade Now button:
If there is no update software on the card or you did not first extract the files, you will get a note as
pictured below.
Only when the system finds the correct
files on the card will the process
continued.
Once the system update software is detected,
the small light in the top left corner of the
Upgrade Now button will turn green. Once the button
is pressed, the Dynavin will begin downloading the
firmware (do not remove the SD card). Once it has
finished downloading, the unit will restart and install
the update automatically.
I
t is possible that you will
see a black screen for a brief time.
The whole process will take about 3-5 minutes.
To Next Page
Loading...
