B-9
MODEL 200IX/250IX BLOWER INSTALLATION
Model 200iX/250iX In Ground Blower Installation
Version 4 High Pressure Blower Installation Guide
5 Insert a plastic cap in both ends of each arm.
6 Place two 1/4-inch thick poly washers around the pin on the blower mount.
7 Place the lower blower arm over the blower mount pin.
8 Place a 3/8-inch thick metal washer on top of the lower blower arm.
9 Secure the lower blower arm using the clamp lever.
10 Place a 1/8-inch thick poly washer around the pin on the upper blower arm.
11 Insert the pin on the upper arm into the lower arm.
12 Place a 1/8-inch thick poly washer around the pin on the blower assembly.
13 Insert the pin on the blower assembly into the upper arm.
The blowers can run at any time once the cord is plugged into a power
source.
Figure B-6: Install the Right Blower Assembly
right blower
assembly
aluminum washer
1/4-inch thick
poly washer
lower blower
arm
clamp lever
upper blower
arm
To Next Page
Loading...
