Eaton 9130 - 1 Introduction

Eaton 9130 700/3000 VA UPS User’s Guide 164201718—Rev 7 www.eaton.com/powerquality 1
Chapter 1 Introduction
The Eaton
®
9130 uninterruptible power system (UPS), protects your sensitive electronic equipment from the
most common power problems, including power failures, power sags, power surges, brownouts, line noise,
high voltage spikes, frequency variations, switching transients, and harmonic distortion.
Power outages can occur when you least expect it and power quality can be erratic. These power problems
have the po
tential to corrupt critical data, destroy unsaved work sessions, and damage hardware – causing
hours of lost productivity and expensive repairs.
With the Eaton 9130, you can safely eliminate the effects of power disturbances and guard the integrity of
your equipment. Providing outstanding performance and reliability, the Eaton 9130's unique benefits include:
l
True online double-conversion technology with high power density, utility frequency independence, and
generator compatibility.
l
Advanced Battery Management (ABM
®
)technology that uses advanced battery management to increase
service life, optimize recharge time, and provide a warning before the end of useful battery life.
l
Selectable High Efficiency mode of operation.
l
Rackmount models in a space-optimizing 2U size that fits any standard 19" rack.
l
Standard communication options: one RS-232 communication port, one USB communication port, and relay
output contacts.
l
Optional connectivity cards with enhanced communication capabilities.
l
Extended runtime with up to four Extended Battery Modules (EBMs) per UPS.
l
Firmware that is easily upgradable without a service call.
l
Emergency shutdown control through the Remote Emergency Power-off (REPO) port.
l
Backed by worldwide agency approvals.
Figure 1 shows the Eaton 9130 rackmount UPS, and Figure 2 shows the optional rackmount EBM.
Figure 1. The Eaton 9130 Rackmount UPS
Figure 2. The Eaton 9130 Rackmount EBM