Eaton 9355 - Page 47

Eaton 9355 UPS (10/15 kVA) User’s Guide 164201594—Rev H0 35
Figure 16. Removing the Vertical Bracket
M10 Bolt
M4 Screws
3. Reinstall the M4 screws to the UPS (see Figure 16).
Figure 17. Reinstalling the M4 Screws and Remove Pallet Brackets
M4 Screws
Pallet Bracket (x2)
(Secures the rear UPS
leveling feet to the pallet)
4. Remove the M10 bolts from the two Pallet Brackets securing the leveling feet to the pallet (see ).
5. Repeat Steps Step 1 through Step 4 to remove the vertical bracket on the other side.
6. Remove the front cover from the bottom cabinet to access the front shipping bracket.
Press and release the handle latch at the bottom of the cover and then lift the cover up and off the cabinet.
7. Remove the three M10 bolts securing the rear shipping pad to the pallet and remove the shipping pad (see
Figure 18).
NOTE Hold the back of the cabinet so that the bolts can be removed easily without the cabinet
rolling backward.
UPS System Installation