Eaton 9390 - Page 76

61 Eaton® 9390 (100–160 kVA) UPS Installation and Operation Manual 164201604—Rev F
Press the SSEETTUUPP pushbutton on the kW Demand Log Summary Menu bar to display the Current kW Demand
Log Setup screen 1.
The Current kW Demand Log Setup screen 1 displays the current user–defined log settings. If no log settings
are configured, the screen will display KW LOG DISABLED. Figure 31 shows the Current kW Demand Log
Setup screen 1.
To return to the kW Demand Log Summary screen, press the
USING THE CONTROL PANEL
Eaton 9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual S 164201603 Rev 4
8-3
8.2 Using the Main Menu
The UPS main menu bar allows you to display data in the information area to help you
monitor and control UPS operation. The following menus and options are available:
Menu Option Description
EVENTS Displays the list of Active System Events and a historical log of system events.
METERS Displays performance meters for the system or critical load.
CONTROLS Displays the System Controls screen.
SETUP Allows you to set the display contrast, set the date and time for the time stamp,
configure the UPS serial communication ports, and view the firmware version numbers.
LOAD OFF De-energizes the critical load and powers down the UPS.
Returns to Main Menu and Mimic screen from the Events, Meters, Controls, or Setup
screens. Returns to the main System Setup Level screen from a setup submenu.
8.2.1 Mimic Screen
Figure 8‐3 shows the Main Menu and Mimic screen. To select the Mimic screen from
the Events, Meters, Controls, or Setup screens, press the
pushbutton on the
current menu bar.
The Mimic screen shows the internal components of the UPS cabinet and a real‐time
graphical representation of the operating status of the system.
TIME: 11 : 35 : 43 DATE: 02 / 25 / 2004
CONTROLS LOAD OFF
METERSEVENTS SETUP
OUTPUT
BATT
UPS
INPUT
STSW
BYPASS
Figure 8‐3. Main Menu and Mimic Screen (Normal Mode)
pushbutton on the menu bar.
FFiigguurree 3311.. CCuurrrreenntt kkWW DDeemmaanndd LLoogg SSeettuupp SSccrreeeenn 11
CURRENT KW DEMAND LOG SETUP
CHANGE
TIME INTERVAL MONITORED
MAXIMUM LEVEL (KW)
3 MINUTES
*** KW
Using the Control Panel
For Internal Use Only