Eaton EAO-6206A - Lubrication

11
EA(B)O-6X06 01/2018 Rev. 1 1. General Information
Lubrication
Draining
Drain transmission oil while the oil is warm.
To drain oil, remove the magnetic drain plug. Clean
the drain plug before reinstalling it.
6106/02
Clean case area around oil ller plug, remove the plug
and rell the transmission until lubricant level is aligned
with the bottom of the ller plug hole.
The amount of oil varies with the position of vehicle
related to the ground and the installation angle of
transmission. Before relling, place vehicle on a at
and level surface.
NOTE: Do not add oil above the recommended level.
This will cause the oil to be forced out through the front
bearing cover, shift lever housing cover, etc.
Correct Oil Level
Incorrect Oil Level
Electro-Hydraulic Control Unit
The oil level of the electro-hydraulic control unit may be checked either on the vehicle or removed from the
vehicle, installed on the transmission or on the workbench support tool, always keeping the unit leveled.
Recommended oil for the hydraulic control unit: Tutela CS Speed, Ref #1508.
Service Type Oil Change Interval Check Oil Level Every
Regular Not required 10,000 km
Heavy Duty Not required 7,500 km
O󰀨-Road Not required 50 hours
Electro-Hydraulic Control Unit Oil Capacity
1.2 liters
RellingOil level check
Before checking oil level, clean case area around ller
plug and if necessary, add enough oil to maintain the
proper oil level.
CAUTION! Do not mix lubricant of
dierent types and brands, as this may
cause incompatibility issues.
Oil Capacity
5,0 liters