162
4. Electro-Hydraulic Control Unit 01/2018 Rev. 1 EA(B)O-6X06
0128-18
Important Assembly Checks
When completing the assembly, perform the following checks:
1. If the plastic lm is installed in the reservoir cap, remove it, otherwise the system may be damaged or
malfunction.
2, Perform the oil reservoir level check procedure as instructed by the manufacturer and, if necessary, complete
the level.
2
1
4. Note that after purge the reservoir level has dropped.
See the before (1) and the after (2).
5. At the end of the operation, complete the level and clean
all oil residue.
Electro-Hydraulic Control Unit
Disassembly and Assembly
To Next Page
Loading...
