Eaton EAO-6206A - Selection or Coupling Sensors Replacement

139
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
Electro-Hydraulic Control Unit
Disassembly and Assembly
0020-18
Assembly
1. Insert the bolts and tighten them into the specied
torque.
2. Using a Torx T20 wrench loose the two sensors bolts.
0022-18
0023-18
0021-18
ATTENTION! The sensors have a guide
pin that ts into a hole in the housing.
Therefore when removing them, raise
evenly, to avoid the breakage of the pin.
Selection or Coupling Sensors
Replacement
Disassembly
1. Release the sensor connector.