102
3. Disassembly and Assembly 01/2018 Rev. 1 EA(B)O-6X06
26. Install the sixteen rear case retaining capscrews to the
front case, being thirteen above (Figure A) and three
underneath (Figure B) the ange. Tighten capscrews in
a criss-cross tightening sequence to the torque of 19-26
N.m (14-19 Lb.ft). Use an 11mm hex socket.
27. Install the two retaining capscrews of the shift rails’ rear
support. Use an 11mm hex socket.
NOTE: Aply Dow Corning 780 sealant onto the
capscrews contact face. Tighten to the torque of
19-26 N.m (14-19 Lb.ft).
28. Install the PTO cover and tighten capscrews in a criss-
cross tightening sequence. Use an 11mm hex socket.
NOTE: Apply Dow Corning 780 sealant onto the
cover contact surface. Tighten capscrews to the
torque of 30-35 N.m (22-25 Lb.ft).
6964 - Figura A
6966 - Figura B
6962
6975
Transmission Assembly
To Next Page
Loading...
