46
3. Disassembly and Assembly 01/2018 Rev. 1 EA(B)O-6X06
21. On the transmission model having an output yoke,
install the special tool EEA-17503 to block the output
yoke (Figure A). On the transmission model having an
output ange instead of the yoke, install the special tool
EEA-17503 with tool EEA-17504 to block the mainshaft
(Figure B).
22. With a sliding T-handle and 24mm hex socket, remove
the output yoke (or ange, depending on the transmission
model) retaining bolt and washer.
0567 - Figura A
5957a - Figura B
6934
20. With an 11mm hex socket, remove the three capscrews
securing the shift rails’ front support.
6960
23. Using a puller, remove the output yoke (or flange,
depending on the transmission model).
Transmission Disassembly
To Next Page
Loading...
