74
3. Disassembly and Assembly 01/2018 Rev. 1 EA(B)O-6X06
6085
6083
6087
6091
60886090
2
1
6084
1
13. Remove the sleeve and the three keys of the 3rd and
4th speed synchronizer.
NOTE: Pay attention not to drop and lose the keys.
15. Using the special tool EEA-17131 supported in the lower
face of the reverse speed coupling hub, remove together:
the hub and the rear bearing cone.
16. Remove the reverse speed gear.
14. Place the protecting device (1) on the mainshaft “pocket”
bearing end to protect the bearing seat. Now, invert the
shaft position and place this end (with the protecting
device) in the tool EEA-17506 (2), placing the shaft with
the rear (yoke) end facing up.
Mainshaft
To Next Page
Loading...
