Eaton easyE4 series User Manual

4. Operation
4.6 Transfer program to the easyE4 device
easySoft 7 Project View\Project\Card...
Figure 67: The program was transferred to the memory card.
Close the window
Remove the microSD memory card from the drive.
Insert the microSD memory card into the slot on the easyE4 base device.
→ Section "Inserting a microSD card", page 62
The easyE4 device will be ready for operation.
Apply the corresponding supply voltage while observing all relevant safety instruc-
tions.
The easyE4 device will start running the program (depending on the operating
mode).
or
Transfer the program from the microSD memory card to the device if you did not
define the program as the starting program.
→ page 150
118
easyE4 11/18 MN050009 EN www.eaton.com

Eaton easyE4 series Specifications

General

Brand	Eaton
Model	easyE4 series
Category	Relays
Language	English