7.14.1 Configuring the password on a base device with a display 476
7.14.1.1 What happens if you forget your password or enter the wrong
password? 478
7.14.2 Configuring the password in easySoft 7 479
7.15 Configuring the memory card and device ID 481
7.16 Time and Date setting 482
7.16.1 Time and date on a base device with a display 482
7.16.2 Setting time and date in the easySoft 7 484
8. microSD memory card 487
8.1 Automatic booting from the card 488
8.1.1 Preparing the card in the PC for booting with easySoft 7 488
8.1.2 Preparing the card in the easyE4 device for booting with
easySoft 7 491
8.1.3 Preparing the card for booting on the easyE4 device itself 495
8.2 Reset – resetting the device to factory settings 497
8.3 Loading new operating system 498
8.4 Setting a splash screen for the EASY-E4-...-12...C1 display 500
9. easyE4 inside 501
9.1 Program execution 501
9.2 Transfering an existing circuit diagram 504
9.3 Timing characteristics of expansion devices 505
9.4 Time behavior of the inputs and outputs 506
9.4.1 Delay time on EASY-E4-DC-... devices 507
9.4.1.1 Delay time with DEBOUNCE activated 507
9.4.1.2 Delay time with DEBOUNCE deactivated 508
9.4.2 Delay time on EASY-E4-UC-... devices 509
9.4.2.1 Delay time with DEBOUNCE activated 509
9.4.2.2 Additional delay time due to bouncing pushbuttons 510
9.5 Device information 511
9.6 Operating states 512
9.7 NET network 513
10. Diagnostics messages of the operating system 517
10.1 Transistor outputs (overload / short circuit) 518
easyE4 11/18 MN050009 EN www.eaton.com
9
To Next Page
Loading...
Need help?
General