Eaton easyE4 series User Manual

IE 418
Imprint 2
Impulse relay 127
Incremental encoder 237
Initial commissioning 75
Initialization mode 313
Input delay 469
Installation 37
Installation position
SD card 38
Selection 38
Integer value 397
Integral term 273
Intended use 19
Interface
User function block 437
Interfaces
Ethernet 64
Interrupt 418, 424
Interrupt function block 418, 424
Counter-controlled 405
Time-controlled 424
Interrupt load 410, 428
Inversion
Contactor function 129
Inverting
Contact 135
IT - Interrupt function block 424
J
JC - Conditional jump 386
Jog mode 294
Jump 386
Jumps 144
K
K
MX - data multiplexer 322
Know-how protection
User function block 437
KP 279
L
Label 25
Language 362
Language changeover 361
Languages 361
Changing on the device 79
Latching button 377
Latching relay 128
LB - Jump label 391
LED
Checking of the NET 571
LED ETHERNET 77
LED POW/RUN 76-77
Less than 244, 256
LI 275
Life signal 571
Lifespan
Backlight 75
LIFO 334
Limits of PW pulse width modulation function
block 269
Load torque
PO - Pulse output 293
Loading new operating system 498
Loading programs onto multiple NET stations 541
Location of use 38
Lower and upper limits 302
LS 259
LT 244, 256
easyE4 11/18 MN050009 EN www.eaton.com
595

Eaton easyE4 series Specifications

General

Brand	Eaton
Model	easyE4 series
Category	Relays
Language	English