Eaton i-on16 - Page 47

i-on16 4. Administration
Page 41
If you are a Normal User:
6. Press .


7. Press  until the display shows:


8. Press .
The display asks you to press one
of the buttons on the remote
control or two-way keyfob.
Note: If you already have a device
allocated to you then the screen
will display “Delete Remote?”.
See page 43.


9. Press any button on the device
that you wish to register. Hold the
button down until you see the
transmit LED flash.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:
The control unit learns the identity
of the device and links it with your
access code.
If the control unit has already
learned that device then you will
hear a low tone and the display
tells you that the device is already
in use.


followed by:


If you do not wish to register a device press .
If you have a device and want to know who it belongs to then use the Test -
Remotes menu option, see page 49 .