Eaton i-on16 - Allowing Fob-2 W-4 B;727 r to start a HUA

4. Administration i-on16
Page 72
Operate an Output
To program a remote button to operate an output:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:


5. Press .


6. Press  until the display shows:


7. Press .


8. Press .


9. EITHER
Press the button on the remote
control that you wish to program.
Hold the button down until you
see the transmit LED flash.
The display shows the identity
and owner of the remote control,
and the button you pressed. Go
on to step 10.
Note: You cannot reprogram the unset
key on a remote control or a
FOB-2W-4B to operate an
output.


OR (if you do not have the remote in
your possession)
a) Press .
The display presents a list of the
registered remote controls and
their users.

