Eaton Power Xpert 9395 - Figure 4-4. ISBM and UPM Sections Joined

P-164000477 9395P750 kVA / 900 kVA and 1000 kVA / 1100 kVA 37
Revision 002 User’s and Installation Guide
.
Figure 4-4. ISBM and UPM sections joined
11. Locate the hardware kit (packed inside a drawstring bag tied to the left middle panel of the UPM
section). Locate two flat brackets and screws from the field kit. Align the holes in the flat brackets
over holes in the top rear and top front of the ISBM and UPM cabinet sections. Secure the brackets
with the screws from the field kit (see Figure 4-5).
12. Locate one flat bracket and screws from the field kit. Align the holes in the flat bracket over holes in
the front base of the ISBM and UPM cabinet sections. Secure the bracket with the screws from
the field kit (see Figure 4-5).
13. Proceed to Section 4.4.
1 Protective cover panels
2 UPM wireway (Power wiring harnesses are coiled in this area)
1
2