Eaton PowerXL - Page 57

3 Installation
3.3 Mount ing
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives 05/21 MN040058EN www.eaton.com 53
Figure 26: Fixing on a mounting rail
Dismantling from mounting rails
▶ To remove the device, push down the spring-loaded clip. A cutout
marked on the lower edge of the device is provided for this purpose.
A flat-bladed screwdriver (blade width 5 mm) is recommended for
pushing down the clip.
Figure 27: Dismantling from mounting rails
2
1
VA
R
EMC
VAR
EMC
2
1
3
VAR
EMC
f 5 mm
(f 0.197“)