EBS Active Track - Operations -> Device Monitor; Operations -> Restore Default Settings; Operations -> Send; Operations -> System Events History

33
Configuration
© 2013 EBS
9.2.2.9 Operations -> Send
This function is analogical to the above one, at the same time it enables data saving
into EEPROM module. There is also possibility to set correct time into Active Track
device. Correct saving is confirmed with message on a screen.
9.2.2.10 Operations -> System events history
„Events history” provides information about last events stored in Active Track device
memory. See chapter Events history
9.2.2.11 Operations -> Device monitor
“Device Monitor” provides real-time information on Active Track device state. See
chapter Device Monitor
9.2.2.12 Operations -> Restore default settings
If operation “Read” finishes with error message (e.g. if access code is unknown) it is
possible to come back to default settings by selecting “Restore default settings”. On
the screen the will appear following message “Do you want to overwrite current
configuration with default values?” After confirming the following window shall
appear:
61
60