EBS Active Track - APN Parameters; Apn; DNS1 and DNS2; User ID

37
Configuration
© 2013 EBS
9.2.3.1.2 APN Parameters
Note:
This group will be inactive if device is to operate in SMS mode.
9.2.3.1.2.1 APN
Parameter depending on GSM network operator that supplies GPRS (SMS) services. It
provides GSM network access point name.
It possible to obtain a private access point. In this case a name will be provided by
GSM network operator.
9.2.3.1.2.2 User ID
When using public APN , user ID is mostly not required. For private APN this
parameter shall be obtained from operator (it is impossible to be granted access to
GPRS network without it).
9.2.3.1.2.3 User password
When using public APN , user ID is mostly not required. For private APN this
parameter shall be obtained from operator (it is impossible to be granted access to
GPRS network without it).
Note:
Private APN provides for higher system security.
9.2.3.1.2.4 DNS1 and DNS2
It determines address of main and backup DNS server (Domain Name System).
If IP server address has been entered in form of domain it is required to provide
minimum one DNS address.
9.2.3.1.3 Primary server parameters
Note:
This group will be inactive if device is to operate in SMS mode.
9.2.3.1.3.1 Server address
It is address of receiver of monitoring system (OSM.2007) or computer where
“Communication Server” software has been installed , e.g. 89.123.115.8. This address
may be provided in domain name of server, e.g. module.gprs.com. In this case it is
required to provide minimum one address of DNS server.