71
Indicating work mode
© 2013 EBS
Read-out mode: repeated (RFID=5,5)
After starting of RFID transponder (see: RFID transponder read-out ) device
waits for bringing near to the RFID tag. Wait time (15 seconds) is signalized by light
on "Read-out" button. Device confirms RFID read-out by double, short acoustic signal
and switching "Read-out" button light off and on. Next, device waits 5 seconds for
next RFID read-out. Each read-out is confirmed in the same way. Data is transmitted
after 5 read-outs (FIFO rule)
Data transmission
Data transmission is being signalled with quick flashing of “Checkpoint”
button.
Data transmission
Making out-going voice calls
Procedure of making out-going voice calls begins with pushing and holding
"Call me" button. "Checkpoint" LED starts to blink (like when transmitting data). After
2-3 seconds acoustic signal is generated. Holding down the button will generate next
acoustic signal (after 2 seconds). Then "Checkpoint" button light will start to blink
with frequency of 1Hz.
Battery low
When battery low, it is being signalled with 2-hour advance before switching
off. “Panic” button flashes every 5 seconds and there are two longer sound signals
every minute. It is recommended to charge the device at once (for more information,
go to Battery charging ).
64
19
To Next Page
Loading...