EBS Active Track - Tilt Detection Configuration

42
Active Track (beta version)
© 2013 EBS
9.2.3.3.1.2 Tilt detection
The device, thanks to the built-in motion sensor, can detect and signal its incorrect
rest position. The functionality may be useful in transport, if a correct position of the
package is required throughout the way. In such case it is enough to properly
configure the device and firmly attach it in a correct position inside the package.
The adjustable parameters are:

Rest position – defined neutral position of the device

Tilt – threshold of deviation (in degrees) from any of the device’s axes, above
which it determines deviation from the rest position

Tilt time - time following which the device which deviated from the rest position
generates the Tilt alarm

Pre-alarm - functionality allowing the user to get information on detection of
deviation before the Tilt alarm is generated

Time of tilt before the pre-alarm generation - time, after which the device
signals detected deviation to the user
Note:
The method of pre-alarming the device’s user of the Tilt function activation (in
other words: of the approaching generation of Tilt alarm) is described in point
Microphone & Speaker .
9.2.3.3.2 RFID tags
The RFID tags tab allows for configuring multiple read-outs of RFID points by the
Active Track device.
Tab is active only for device version with built in RFID transponders reader.
44