STARTER SYSTEM
CS-600
9
2-1 Disassembling starter assembly
1. Remove sprocket guard (A).
2. Remove brake lever (B).
3. Remove four screws and remove starter assem-
bly (C) from unit.
4. Pull out starter rope about 30 cm (12 in) and
hold rope reel (D) by hand. Loop excess rope in
rope reel notch (d) as shown.
5. Rotate rope reel (D) counterclockwise to release
tension of rewind spring.
6. Remove bolt (E).
7. Remove washer (F) and starter drum (G).
8. Carefully remove rewind spring and case (H)
as one piece. Rewind spring is under tension and
may release unexpectedly.
WARNING DANGER
Wear eye protection and take care when
removing starter drum. Rewind spring may
unwind suddenly and cause personal injury.
A
D
d
B
C
E
F
G
H
To Next Page
Loading...
