MAINTENANCE GUIDE
CS-600
75
Intervals
Inspecting point Service Reference 3 months 6 months
Daily or or
100 hours 300 hours
Screws and bolts * Retighten / Replace
Air fi lter Clean 4-1
Inspect / Replace 4-1
Carburettor Inspect / Repair 4-8 to 4-14
Fuel leaks Inspect / Repair 4-2, 4-3
**
Fuel line Inspect / Repair 4-3, 4-5
Cooling system Inspect / Clean 8-2
Spark plug Clean / Regap 3-2, 3-3
Inspect / Replace 3-3
Fuel strainer Clean / Replace 4-2
Leads and connections Inspect / Repair 3-5
Fuel tank Clean inside. 4-3
Muffl er and exhaust port Clean 8-3
Starter system Inspect / Repair 2-1 to 2-4
Oil tank Clean inside.
Oil strainer Clean / Replace 7-1
Sprocket Inspect / Replace 1-5, 5-1
Guide bar Inspect / Clean
Chain brake Inspect / Repair 6-1, 6-2
Daily:
Inspecting in every services.
IMPORTANT:
Service intervals shown above are maximum. Actual use and your experience will determine
the frequency of required maintenance.
* Retighten the following screws and bolts after fi rst 1 week use, and every 3 months.
Cylinder cover screws (3 pcs.)
Starter assembly screws (4 pcs.)
Anti-vibration spring screws (2 pcs.)
Front handle screws (4 pcs.)
Muffl er bolts (4 pcs.)
** Inspect after every refuel.
11-3 Service Intervals
To Next Page
Loading...
