IGNITION SYSTEM
CS-600
22
3-10 Inspecting fl ywheel and key (continued)
5. Remove starter pawls. Then set Puller 897501-
03938 (C) on fl ywheel as shown.
6. Tighten two nuts on the puller alternately to re-
move fl ywheel.
7. Inspect woodruff key for damage or shearing.
Replace as required.
.
8. Wipe off oil from taper part of crankshaft before
assembling fl ywheel.
9. Install woodruff key into key groove.
10. Reinstall starter pawls (Refer to “2-4 Replacing
starter pawl”).
11. Align fl ywheel key groove with woodruff key on
crankshaft. Install fl ywheel and fasten fl ywheel nut
clockwise.
C
To Next Page
Loading...
