STARTER SYSTEM
PB-8010, EB810
8
2-1 Disassembling starter assembly
1. Remove 3 bolts (A) and remove starter assem-
bly (B) from unit.
2. Pull out starter rope (C) about 30 cm (12 in) and
hold rope reel (D) by hand. Hook excess rope on
rope reel notch (d1) as shown.
3. Rotate rope reel (D) clockwise to release ten-
sion of rewind spring.
4. Remove screw (E), thrust washer (F), shutter (G),
spring (H) and washer (J) from starter assembly.
5. Remove rope reel (D) from starter case (K)
slowly to prevent rewind spring (M) from unwind-
ing.
d1
C
D
E
F
G
H
J
WARNING DANGER
Wear eye protection and take care when
removing rope reel. Rewind spring may un-
wind suddenly and cause personal injury.
D
M
K
A
B
To Next Page
Loading...
