IGNITION SYSTEM
PB-8010, EB810
17
3-5 Inspecting ignition switch
1. Loosen bolt (A).
2. Disconnect primary wire (B) and ground wire (C).
3. Connect Ohm-meter or Multi-meter to primary
wire (B) and ground wire (C) as shown.
4. When ignition switch is in “RUN” position, the
tester should indicate infi nite resistance.
5. When ignition switch is in “STOP” position, the
tester should show that circuit is in conducting
state (closed circuit).
6. If not, replace the ignition switch with new one
(Go to “3-6 Replacing igntion switch”).
3-4 Inspecting and Replacing spark plug cap and coil
1. Pull off spark plug cap (A).
2. Apply some oil in the spark plug cap (A) for easy
removal from high tension lead (B).
3. Pull spark plug cap (A) away from high tension
lead (B).
4. Inspect spark plug cap coil (C) for corrosion
and correct connection. Inspect spark plug cap for
cracks. Replace them as required.
NOTE:
Make sure spark plug cap coil (C) contacts
center core of high tension lead.
5. Coat end of high tension lead (B) with small
amount of oil, and insert the high tension lead (B)
into spark plug cap (A) as shown, until the spark
plug cap coil (C) is properly seated in the cap.
A
B
A
B
A
B
C
Coat with oil
C
To Next Page
Loading...
