ENGINE
PB-8010, EB810
50
7-6 Inspecting cylinder
1. Loosen two bolts (A) and remove cylinder cover
(B).
2. Loosen four bolts to remove cylinder from en-
gine.
NOTE:
When removing cylinder solely for the pur-
pose of inspecting cylinder, leave ignition module,
and intake insulator to avoid extra work.
NOTE:
Gently tap cylinder with plastic mallet at
carburetor and/or muffl er sides of the cylinder head
if it is diffi cult to remove.
3. Inspect cylinder combustion chamber and clean
with a plastic or wooden scraper if carbon is found.
NOTE:
Do not use metal tools, or damage to cylin-
der wall may result.
4. Inspect cylinder wall and replace with new one
if plating is worn, peeled away, scored or exposing
cylinder base metal.
A
B
To Next Page
Loading...
