Echo shindaiwa PB-8010 - Inspecting Ignition Coil Resistance

IGNITION SYSTEM
PB-8010, EB810
21
3-7 Inspecting ignition coil resistance
1. Connect Ohm-meter or Multimeter to spark plug
cap coil (A) and crank case (B).
Secondary coil resistance:
785 - 1185 Ω
2. If the meter reading indicates infi nite
resistance, remove spark plug cap and spark
plug cap coil, and measure resistance between the
conduction wire of high tension lead (C) and crank
case (B).
3. If the coil resistance is not in the spec. range,
replace the ignition coil with new one. (Go to “3-8
Replacing ignition coil”).
A
B
B
C